Toyota Truck Tech
A few yota tech links ive had on my favorites for a while

Toyota Mini Truck Front Axle Identification
79-80 no gusset
81-83 short gusset (to u-bolts)
84-85 long gusset (past u-bolts)

Stock Toyota front axle measurements for comparison:
55.5" wide, 29" spring perch centers, '79-85 Toyota trucks and 4runners, SA Hubs
58.25" wide, 29" spring perch centers, '79-85 Toyota trucks and 4runners, IFS Hubs
63.5" wide, (set up for coil springs) 90-97 FJ80 and FZJ80 Landcruisers
'86-95 IFS front end is about 58.5" wide
'93-98 T100 IFS front end is about 65" wide

Toyota Rear Axle Widths:
55" wide, '79-85 4wd trucks/4runners - 6 Lug
58" wide, '86-95 4wd trucks/4runners - 6 Lug
56" wide, '79-95 2wd Trucks - 5 Lug
60.75" wide, '95.5-up Tacomas/4runners
66.75" wide, '93-98 T100 trucks

Square drive shaft
http://infohost.nmt.edu/~jscarbro/driveshaft.htm

Carb Tuning
http://www.pirate4x4.com/forum/showt...hreadid=165996



Ratio Ring/Pinion Color Crawl:Ratio
3.42 ...42/12... Purple ...31:1
3.90 ...39/10... Red... ...36:1
4.10 ...41/10... Pink.. ...37:1
4.11 ...37/09... Orange ...37:1
4.30 ...43/10... Blue.. ...39:1
4.37 ...35/08... Green. ...40:1
4.56 ...41/09... Yellow ...41:1
4.88 ...39/08... White. ...44:1
5.29 ...37/07... None.. ...48:1
5.71 ...40/07... None.. ...51:1

Exo Cages
http://www.pirate4x4.com/forum/showthread.php?t=95564

SAS Pics and Dimensions thread
http://www.pirate4x4.com/forum/showthread.php?t=321699

Spring Hangers - Front - SAS
http://www.pirate4x4.com/forum/showthread.php?t=321699
http://www.pirate4x4.com/forum/showt...threadid=76595

Vaccuum Line Diagram
22R, 22RE, 22RTE diagrams
http://www.pirate4x4.com/forum/showthread.php?t=579557
22RE Vaccuum line diagram
http://mywebpages.comcast.net/pneumya/images/85efi.jpg

carb tuning link doesn't work anymore.

I shall fix that thanks

http://www.pirate4x4.com/forum/showthread.php?t=165996
new carb tuning link not as easy to read but it gets the job done

Running ifs hubs on a toy solid axle

you need ifs hubs from a 86 and up toyota pickup
fj80 rotors
4cylinder or v6 calipers
1/2 inch drill bit
4 1/2 inch by 2" bolts nylock or stover
fj 80 wheel studs

you must drill the caliper bolt holes out and use a nut and bolt